ValterMoto Billet Clutch Cover Protector - VT-EPCA00100
Complete fitment list at bottom of this page.
Made in Italy by ValterMoto, this diminutive gorgeously machined piece promises vital lower engine protection, while not sacrificing the looks of your V4.
Installation is straightforward and you do not have to drain any oil or break any oil seal to install.
Tightening torque is 12nm (8.85 ft/lbs)
*Please note: If fitting to 2017 and later models, the stock plastic engine cover must be removed before installation AND it is recommended to purchase quantity 5 of M6x25 Bolt 857429 because some stock fasteners can not be re-used.
**A helpful note about this part regarding '21 and later V4's: While this part fits and bolts on just fine, there is no matching stator cover, since '21 and newer V4's have a differently shaped stator cover that is thicker with differently positioned mounting holes.