Unpainted 2016 Spec Bellypan Kit For Tuono V4.
This kit uses all OEM Aprilia parts to allow you to fit an UNPAINTED/RAW version of the '16-'20 Spec RSV4 RR lower fairing onto your '11-'15 Tuono V4** (all variants), and '16-'20 Tuono V4 1100** (all variants)
- Chin Fairing
- LH Lower Fairing, '16-'20 Spec RSV4 RR, Raw Plastic, Unpainted
- RH Lower Fairing, '16-'20 Spec RSV4 RR, Raw Plastic, Unpainted
- RH Lower Engine to Bodywork Clamp
- LH Lower Engine to Bodywork Clamp
- Rear Fairing Support Clamp
- Plastic 2-Piece Rivet (quantity 6)
- Fairing Screw Washer (quantity 5)
- Rubber Wellnut M5
Kit comes un-assembled. Youtube installation video here. Bracket locations can be found on page 17 of the 2016 RSV4 RF Parts Diagram upon which this kit is based.
Kit requires you to reuse the six button head bolts from your stock Tuono V4 lower fairing and all of the bolt clips.
***Please note: The panels in this kit are raw plastic; they are unpainted and un-primered (see detail photos)
**Please note: This kit only fits on Tuono V4 if an Akrapovic full system has been fitted. The Butterfly controller pivot on the stock collector will melt these fairings.
*Please note: The red arrows in the photo below indicate areas that remain visible after the bellypan is fitted. Most owners trim these areas off: