Rizoma No-Cut Turn Signal Cable Installation Kit**
Kit includes 2 kits, or, enough to mount two turn signals.
Want to install Rizoma Turn signals, but don't want to cut your stock wiring harness in any way? Then buy this kit that allows you to plug your Rizoma turn signals directly into your stock Aprilia* or Moto Guzzi* wiring harness.
*Please note: This installation kit is NOT guaranteed to fit all Aprilia nor all Moto Guzzi models. Inspect your connectors before ordering. The following list shows known excluded vehicles/locations:
- Does not work on front turn signals of '06-'10 Tuono
- Does not work on on Rear Signals of Moto Guzzi V7
- Does not work on Moto Guzzi Griso
- Does not work on rear turn signals of RSV4 (does work on fronts)
- Does not work on rear turn signals of RS660 (does work on fronts)
- Does not work on any Tuono V4
- Does not work on Shiver 900
- Does not work on Shiver 750
- Does not work on Dorsoduro 900
- Does not work on Dorsoduro 750
- Does not work on Dorsoduro 1200
- Does not work on Caponord 1200
- Does not work on Caponord 1200 Rally
**Please note: The included connector will look like and have the dimensions shown in the diagram below. If your stock signal wire connector does not look like this, then this connector will not work for you.