- '02-'05 Tuono
- '06-'10 Tuono
- '11-'15 Tuono V4 (all variants)
- '16-'19 Tuono V4 1100 (all variants)
- '07-'10 Shiver
For Moto Guzzi:
- '05-'17 Griso 1100, Griso 1200 8V
If you're looking to install this on a V7 III, you'll also need Rizoma 42mm Bar Riser Kit RZAZ402B
, and a lot of patience. (A 60mm kit
is also available, but not recommended due to inadequate cable and wire lengths)
Handlebar internal diameter at bar end is 14mm
Sold each, delivered as seen in the photo.
Bar does not allow re-use of stock handlebar weights. To mount bar ends or bar end mirrors to this bar see the products at the links below:
Please note: Installation of this handlebar requires drilling of at least two holes for correct location of the LH and RH switch groups. No template is provided.