JetPrime RH Start-Stop Switch
Complete fitment list at bottom of this page.
Free up some critical space on your handle bar and make it look WAY more modern with this Italian made part.
The stock start-stop switch on your V4 has not been updated by Aprilia since 1998. A bike as modern as the Tuono V4 or RSV4 should have switchgear to match.
This plug-and-play switch is not only more modern than the stock unit, but also frees up some handlebar width because it mounts to the back of the stock master cylinder.
Better looks and more handlebar width weren't enough for Jetprime though, this switch also as an accessory momentary two wire button (in grey) on the lower left of the body. You can wire this in for any optional electrical part you want to control.
Image below shows plug-and-play stock connector and the two wires connected to the optional grey button.
*Please note: When installing this part, clamp it over the bar to install, do not slide it up the bar from the bar end. There are wires inside the clamp that can be pinched if slid up the bar. AF1 Racing will not allow returns for switches that are improperly installed.