AF1 Tail Conversion Kit For Tuono V4 - '18 Factory (AF1-2H002241000XN2)
AF1 Racing Tail Conversion Kit, '18 Factory Black
This is the tail section from '18 Tuono V4 1100 Factory.
It is a direct color match for '18-'19 Tuono V4 RR 1100 in Black.
Can also be fitted to '11-'19 Tuono V4 (all variants).
This kit is comprised of OEM Parts and includes all the parts you need to install the beautiful '18 Tuono V4 Factory tail section onto your Tuono V4.
Kit is 100% complete and includes all OEM parts, there will be no surprise trips to the hardware store.
Kit includes all needed fasteners, push pins, and comes with seat bracket with rivet-nuts pre-installed. This kit does require you to re-use some fasteners from the stock Tuono bodywork, this prevents doubling up on hardware you already have from the stock bike.
*Kit does not include seat cowl kit which is sold separately. (RSV4 Passenger Saddle available separately as well).
Installation instructions have not yet been written, but this kit can be installed by any home mechanic that is comfortable with removing the fuel tank (necessary to remove the rear fairing push pins) and removing rear bodywork. A full installation video can be seen on Youtube at this link: RSV4 Tail Conversion For Tuono V4.
Areas to be careful during installation include:
- Installation of rear taillight cover (part #858839) is a little tricky becuase the taillight cover has rolled lips to securley snap in the rear fairing. Care must be taken to first install the rear fairing tabs, then snap in the rear taillight cover.
- The passenger pegs must be removed in order to take off the Tuono V4 rear fairings. Passenger pegs can be re-installed once RSV4 rear fairings have been fitted, but this kit does not include the passenger saddle. Passenger saddle for RSV4 fairings is available at this link RSV4 Passenger Saddle
- A small plastic push pin is used at the forward edge of the Tuono V4 rear fairings. When installing these fairings those push pins are discarded in favor of an M5 clip nut and an M5x12 button head bolt. Both are included in the kit.
Kit allows you to re-use your stock taillight, but clear, black out, or smoked aftermarket RSV4 taillights will fit as well.