FlyHammer Racing GP Gear Change Pedal
Complete fitment list at bottom of this page
If you're like us and can't quite see spending over $600 (or more) for GP shift rearsets, this Italian made shift pedal (or the similar Woodcraft one) are an excellent alternative.
*Please note: This part can also be installed on '17 and later V4's as well, but the inboard side of the pedal may need to be chamfered to prevent contact/interference with the autoblip sensor.
Few countries can produce artist/machinists like Italy can. This gorgeous, shift pedal will allow you to simply and elegantly convert your Aprilia to GP shift.
Made from 6061 Aluminum, and clear anodized, this lever works as good as it looks and includes new pivot bolt, and spacers.
Pedal pivot is ball bearing.
Replacement Toe Piece can be ordered at this link: Toe Peg for FlyHammer Reverse Shifter
Please note: This pedal has been confirmed to fit the stock rearsets only.
Please note: This pedal requires use of high strength threadlock compound on the pivot bolt and the toe piece. High strength threadlock compound can be purchased at this link: Permatex Threadlock Red
Install as seen in the Youtube video link below
Flyhammer GP Shift Lever Video Installation
*Please Note: Flyhammer, being Italian, likes to cosmetically alter the shift lever often. Over the more than two dozen orders we've placed for this part, no two batches have been the same. When ordering this part, expect slight cosmetic differences in the toe piece, dimpling, and pivot washer from what is shown in the images.