Search
Filters
Close
Spider Racing Clip-On Handlebar Kit for RS660
Availability: Special Order
SKU: HSBK-50.25.239.51
$225.99 (USD)

Spider Racing Clip-On Handlebar Kit for RS660

These clip-ons are required if you're planning on running the Spider Racing Top Clamp

CNC machined from 7075 Billet Aluminum

Spider describes these clip-ons as 25mm offset (see attached image), but that 25mm offset (viewed from above) is pretty typical and about the same dimension as the stock RS660 bars. Of perhaps greater importance is that the bars sit some 40mm (1.5 inches) lower than the stock bars. This could result in reduced steering clearance with stock bodywork.

Also note, these clip-ons are not pre-drilled for the locator pins found on the RH and LH switch groups. You will need to drill at least 2 4mm holes in these clip-ons when you install them.

Spider Racing Clip-On Handlebar Kit for RS660

These clip-ons are required if you're planning on running the Spider Racing Top Clamp

CNC machined from 7075 Billet Aluminum

Spider describes these clip-ons as 25mm offset (see attached image), but that 25mm offset (viewed from above) is pretty typical and about the same dimension as the stock RS660 bars. Of perhaps greater importance is that the bars sit some 40mm (1.5 inches) lower than the stock bars. This could result in reduced steering clearance with stock bodywork.

Also note, these clip-ons are not pre-drilled for the locator pins found on the RH and LH switch groups. You will need to drill at least 2 4mm holes in these clip-ons when you install them.

Customers who bought this item also bought
Categories