RhinoMoto 3/4 inch Bar End Extenders, Pair This pair of bar end extenders allows you to easily mount bar end mirrors, or shift your controls outboard to allow easier mounting of GPS, Smartphone, or USB Power Outlets.
Lagerstatus: 5 st i lager
RhinoMoto 3/4 inch Bar End Extenders, Pair
This pair of bar end extenders allows you to easily mount bar end mirrors (CRG Lanesplit
, CRG Arrow
and others), or shift your controls outboard to allow easier mounting of GPS, Smartphone, or USB Power Outlets.
As electronics have become more and more prevalent on modern bikes, the handlebar has gotten increasingly crowded, so much so that there is very little room for traditional clamp-on accessories to be installed. These handlebar extenders get you 3/4 inch more space on each side of the handlebar to make installing clamp-on accessories possible.
Each bar end extender has an M6 allen key recess which makes tightening these thread-in bar extenders more secure than almost every other option on the market.
In addition the bar end extenders are hollow through the middle with M6 threads that allow re-installation of the stock bar end*
, or easy and secure installation of aftermarket bar ends
, or bar end caps
This part is direct fit for all of the following models:
- '21 RS660
- '09-'20 RSV4 (all variants)
- '19-'20 RSV4 1100 Factory
- '11-'20 Tuono V4 (all variants)
- '08-'15 Mana, Mana GT
- '04-'09 RSVR, RSVR Factory
- '06-'10 Tuono
- '07-'11 Shiver 750
For Moto Guzzi:
- '05-'17 Griso (all variants)
- '07-'08 Sport 1200 Breva
Please note: If shifting controls outboard, it will be necessary to re-drill the locator holes for the switchgroup alignment pins. The LSL Drill Guide
makes this very easy to do.