Buccine Grey*** 2016 Bellypan Kit For Tuono V4.
This kit uses all OEM Aprilia parts to allow you to fit the '16 RSV4 RR lower fairing onto your '11-'15 Tuono V4** (all variants), and '16-'20 Tuono V4 1100** (all variants)
- Chin Fairing
- LH Lower Fairing, 2016 RSV4 RR, Buccine Grey
- RH Lower Fairing, 2016 RSV4 RR, Buccine Grey
- RH Lower Engine to Bodywork Clamp
- LH Lower Engine to Bodywork Clamp
- Rear Fairing Support Clamp
- Plastic 2-Piece Rivet (quantity 6)
- Fairing Screw Washer (quantity 5)
- Rubber Wellnut M5
Kit comes un-assembled. Youtube installation video here. Bracket locations can be found on page 17 of the 2016 RSV4 RF Parts Diagram upon which this kit is based.
Kit requires you to reuse the six button head bolts from your stock Tuono V4 lower fairing and all of the bolt clips.
**Please note: This kit only fits on '11-'16 Tuono V4 if an Akrapovic full system has been fitted. The Butterfly controller pivot on the stock collector will melt these fairings. '17-'20 Tuono V4 are unaffected due to different stock muffler/header design
*Please note: The red arrows in the photo below indicate areas that remain visible after the bellypan is fitted. Most owners trim these areas off:
***Please note: While these panels come from the '16 RSV4 RR which is also named "Buccine Grey" the RSV4 panel is a matte finish silver, unlike the high gloss silver on the '16 Tuono V4 1100 RR. Difference can be seen in the photo below: