Crosstrax 1 Inch (25mm) Lowering Driver Pegs, Silver for Stock Rearsets
Sold as a LH and RH Pair
For:
- Tuono 660
- '21 RS660
- '09-'18 RSV4 (all variants)
- '19-'20 RSV4-RR
- '16-'20 Tuono V4 1100 (all variants)
- '11-'15 Tuono V4 (all variants)
- '98-'03 Mille, Mille-R
- '02-'05 Tuono
- '01-'04 Futura
- '04-'09 RSVR, RSVR Factory
- '06-'10 Tuono
- '11-'16 Shiver
- '18-'19 Shiver 900
These anodized aluminum pegs allow you to lower your footpegs 1 inch versus stock without the need to purchase a complete set of aftermarket rearsets.
For maximum benefit from these pegs we also suggest you buy either of the eccentric toe pieces listed below:
These pegs are for the driver only. These are not passenger pegs.
*Please note: Crosstrax/Knight Design refers to these pegs as "The 1 3/8ths Lowering Pegs" on their website, but the actual measured drop when we installed them was just barely over 1 inch. That is why we call them 1 inch and Crosstrax refers to them as 1 & 3/8ths.
**Please note: Does not fit the following models due to their bulged catalytic converters and or heat shields. These pegs will work if you have an aftermarket exhaust on these models
- '19-'20 RSV4 1100 Factory
- '21-22 RSV4 1100 (all variants)
- '21-22 Tuono V4 1100 (all variants)
Comparison photo (Crosstrax vs stock) below:


**Please note: These pegs do not fit Aprilia Tuareg. A full explanation of why they do not fit can be found at this link on www.apriliaforum.com