Brembo Rear Master Cylinder For Mille, Mille-R, RS660, RSVR, Tuareg, Tuono 660, Tuono V2 *See detailed fitment list*
Availability: 1 In stock -- Ready to Ship Now!
Brembo Rear Master Cylinder
Complete fitment list at bottom of this page.
This is the AF1 Racing recommended alternative to OEM Aprilia Part Numbers: 2B007140, AP8133875 or AP8133871, or 852218.
If you are having difficulty bleeding this master cylinder, AF1 Racing recommends to purchase the banjo bleeder kit.
*Please note: If you adjusted the brake pedal push rod (seen in the photo at the bottom of this page) just before your old master cylinder failed, the brake pedal push rod will not be the correct adjustment for this new master cylinder. The push rod should be set up so that it’s rattling loose, and begins to engage the plunger AFTER 2-3 mm of pedal travel.
**Mille, Tuono V2 and RSVR owners Please note: Due to the challenging design of the rear brake system of the above listed bikes AF1 Racing strongly recommends having this part professionally installed to ensure correct rear brake bleeding procedure is followed (Post #6, 7, & 8)
***Mille, Tuono V2 and RSVR owners Please note: owners Please note: The push rod on are recommended to be modified to appear like the photo seen at the bottom of this page.
****Mille, Tuono V2 and RSVR owners Please note: Please note: The push rod dust cap (part number 6 in the diagram below) will have to be removed and refitted to properly mount the revised push rod found on.