Axle Puller Set for '04-'09 RSVR, RSVR Factory, '06-'10 Tuono, '18 Shiver 900, '07-'15 Shiver, '18 Dorsoduro 900, '09-'16 Dorsoduro 750, '98-'03 Mille, '00-'03 Falco, '02-'05 Tuono
Availability: 5 In stock -- Ready to Ship Now!
Axle Puller Set
For:
- '04-'09 RSVR, RSVR Factory
- '06-'10 Tuono
- '18 Shiver 900
- '07-'15 Shiver
- '18 Dorsoduro 900
- '09-'16 Dorsoduro 750
- '98-'03 Mille, Mille-R
- '00-'03 Falco
- '02-'05 Tuono
These simple lathe built delrin axle pullers are compression fit into the unthreaded side of your axle to serve as a grip for pulling the axle out during tire changes.
Set includes a front axle puller and a rear axle puller.
Photo of the puller installed in a front axle can be seen below:
Below are some installation notes provided by the manufacturer:
Make sure there are no burrs or edges inside the axle, then tap into place with a mallet or hammer. it will be a very snug fit going in.
If the guide is too tight, use a file or sand paper to slightly chamfer the edge so that the guide can be tapped in.