OEM Aprilia LED Turn Signal Pair - 2S000048 Slightly smaller than stock, with full LED light boards, an Official Aprilia Accessory that will not cause any dashboard errors For Caponord, Dorsoduro, RSV4, Shiver, Tuono V4 *See detailed fitment list*
Availability: 1 In stock -- Ready to Ship Now!
OEM Aprilia LED Turn Signal Pair - 2S000048
Complete fitment list at bottom of this page.
Slightly smaller than stock (see photos with dimensions below), with full LED light boards, an Official Aprilia Accessory that will not cause any dashboard errors.
Sold as a LH and RH pair.
*Please Note: These signals lengthen your original wiring by approximately 8 inches. Installation at the rear will require removal of the license plate/turn signal support assembly so that the additional length can be tucked inside. At the front, the fairing may need to be removed.
- On Shiver and Dorsoduro models, due to their very small front fairings, finding room for the additional wire length could be challenging.
- Some owners have also noted that the wiring connectors are not correct for '16 Tuono 1100's. Be prepared to cut and splice wires if you are buying these for Tuono V4 1100.
- Some owners have reported that the locating nub (the one the wires pass through) is smaller in diameter than the stock signal's nub. In those cases, a washer may have to be fitted to the mounting bolt hole to add stability.
Signals have non-standard Aprilia connectors. Adapters are included (see photo below):
Adapters allow you to tap into the wires coming of the back of the stock turn signal reflector (see photo below):
Please note: The distance between the wire pass-through hole and mounting hole is 'slightly' narrower on these LED turn signals than it is on the stock turn signals. The difference is less than 3mm and does not prevent a correct looking installation. Image below illustrates difference.
Full dimensions of these signals below: